Jump to content

bikestat

Members
  • Posts

    77
  • Joined

  • Last visited

Everything posted by bikestat
 
 
  1. any contact details for bill beverage?
  2. does anybody know who produces alloy barrels for the 4 speed bantam engine please.
  3. hi guys any advise on what oil to use for the bantam 4 speed gearbox/clutch many thanks
  4. measure outside dia, inside dia,35mm most likely and the thickness then google motorcycle fork oil seals .
  5. thanks guys it was the rear that was more important to me.
  6. hi guys,happy new year does anyone know the front and rear wheel rim / hub offset dimensions for the 350 T regards john.
  7. craig mawlam is the importer and sends them out by post-01793 574936
  8. bikestat

    Magicals

    does anybody know who supplies magicals fork springs now please.
  9. anybody know where i can get my italjet t350 hubs re-lined with a new steel liner and any idea of cost.
  10. pretty sure its 30&1/2 inches
  11. thanks for comments will probably stick with tubed tyres after the replies. has anyone used the talon stainless security bolts?.
  12. update -it would just be on the rear as security bolts seem to be a pain.
  13. thinking of putting tubeless rims on a new bantam build and would be pleased to hear any comments or suggestions good or bad thanks.
  14. just finishing my 4 speed 185 cc bantam project but not sure what gearbox and rear wheel sprockets to start with, the engine has 12t primary sprocket any ideas would be most welcome.
  15. hi,planning to run my ty on putoline tt pre mix just wondering what ratio people are running these days as i am returning to trials after a long break
  16. bikestat

    Mar Betor Forks

    does anybody have info about how the damper assembly goes together on these forks as at the moment its just a box of bits.
  17. hi guys does anyone know how to contact rob homer regarding bantam frames.
  18. craig mawlem at yamaha majesty does them.
  19. roadholders short or long but now very expensive and rare.triumph or bsa four bolt as b25 are popular now and just as good
  20. the reply regarding bad enginnering practice is outrageous you trained in prototype enginnering the same as myself and with 40 years in the game i see nothing wrong with that work at all.my bantam swinging arm has been extended by one inch by cutting the 5/16 flat plate where the spindle sits and welding one inch in no probs in five years.any time served welder would just laugh at that comment.you may need to heat and straighten the arm after welding though.one thing to be aware of is that a lot of people like to mig weld vertical to get a neat finish but you risk getting cold overlap doing that which will introduce a weak point.
  21. thans mate give them a ring next week.
  22. hi,nearly finished building a 4 speed big bore bantam trials bike with pvl ignition and 22mm amal mk 1 carb and could really use some advice on where to start with carb settings ie,slide needle posistion pilot jet main jet etc any advice on this subject would be very welcome. regards bikestat.
 
×
  • Create New...