Jump to content

Clutch Master Cylinder


snowball
 Share

Recommended Posts

post-18568-0-44044200-1435250011_thumb.jpgTrying to put the master back together after welding done but not sure if I'm missing something as the dot4 is not pushing through in the configuration I have. Any tips.

Edited by snowball
Link to comment
Share on other sites

 

Maybe the welding warped or damaged the bore of the cylinder or blocked the tiny holes between the reservoir and the bore? 

Or maybe you just need a new repair kit? You need a new circlip anyway. 

And are you sure the ring belongs there? Can't remember ever seeing one in that place.

Edited by guys
Link to comment
Share on other sites

 
 

Throw the ring away, and get a new circlip.

The ring would hold the piston in too deep in the bore and block the transfer port.

Make sure you have some free play on the lever as well or the same problem will happen. This is critical to the proper operation of AJP master cylinders.

  • Like 1
Link to comment
Share on other sites

 
 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
  • Create New...