Jump to content

Fan Bypass


paulr1983
 Share

Recommended Posts

Hi chaps I've just got a Sherco and the fan has been wired on a switch and by passed from the thermostat I am wanting to put the bike back to normal so does anyone have a clue as what wires will go were if a disconnect the switch

At the same time I would Also like to have a switch on incase the thermostat plays up

Any suggestions??

Link to comment
Share on other sites

 

 
 
 
 
 

You say you still want to use a switch if you find the thermostate fails, well you simply wire it in parallel with the thermostate. Imagine a ladder with the rungs being the thermostate and the switch with the wiring connecting like the side rails.

Link to comment
Share on other sites

 
 
 
 
 
 
 

After having my thermostat fail during a trial, nearly boiling my bike and not being able to finish, I now carry a small link wire (6mm male spade each end if I remember right) that can now be quickly used to link out the thermostat and make the fan run all the time. I also run the bike up to temp and watch for the fan cutting in after each wash off and carb clean.

Link to comment
Share on other sites

 
 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
  • Create New...