Jump to content

Jitsie kill switch on a rev3


diesel2607
 Share

Recommended Posts

Just back from a trial today I have a jitsie magnetic kill switch fitted at section 6 I stopped bike using the kill switch started it again rode the section and at section 7 tried to use the kill switch to stop the bike again and the engine just kept running I have tried the magnet on and and off a few times Aswell as gentle tapping to see if the inside is stuck up but no joy any advice on what I could try would be great

Thanks in advance hopefully get this sorted soon 

 

Link to comment
Share on other sites

 

 
 
 

My kill switch is jitsie no solders underneath just like waterproof Jelly stuff I have rewired the wire I thought was broken and I have a circuit on both the wires but the bike still won't stop when I disconnect the kill switch I have checked continuity from as near to the switch as I can and it seems OK 

Link to comment
Share on other sites

 
 
 
 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
  • Create New...