Jump to content

kingslander

Members
  • Posts

    2
  • Joined

  • Last visited

Contact Information
 
   
  1. thanks for the reply's. lineaway I haven't yet rebuilt the master cylinder as it was only done a few weeks ago. 0007 first I noticed the break dish was always covered in oil, on closer inspection the break pads where the same, when I striped down the capiler the little oring was damaged so I do all seals. bestrcpilot thanks for the tip I must give this ago tried almost everything else
  2. I'm having a lot of trouble bleeding my 05 sherco front breaks, I have already put in new pads,rebuilt pistons and seals and new fluid with no joy. the only way to get pressure on lever is adjust screw fully in, and at that the break doesn't fully lock. any suggestion would be much appreciated thanks
×
  • Create New...