-
Posts
15 -
Joined
-
Last visited
Contact Information
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users. |
-
welcome! im from galway!
-
Thanks for the replies!! And I enjoy ripping stuff apart and putting it back together. Why pay a pro when you can do it yourself and learn more about your bike while doing so? Well that's just how I look at it anyway. I have other bikes to ride so I'm in no rush either.
-
well if i be more exact cant get flywheel off or split case any tips?
-
Hi, I have a 03 sy250 and i was wondering what special tools would i need to take apart the engine to give it a full rebuild? i have attempted it without these tools but it was impossible. any links to where i could get these tools in uk or ireland would be great thanks.
-
Thanks! I ended up getting a length of rod and a lump hammer and just hammering it it took a lot of sweat and a few broken knuckles but its out
-
hi im rremoving the engine from my 03 sy250 and ive gotten as far as removing the rear swing arm bolt but it will not budge any tips? and if i use force to get it out is there anything i need to be careful of breaking or damaging?
-
Maybe try trialstribulations.net
-
Thanks a million you were right about the master cylinder not being fully disengaged I owe you a pint for that advice the Scorpa will see the mountains once again
-
Ya hopefully that will do it! Should it take long for the clutch to start working right after bleeding?
-
Where about in the west? I'm from galway!
-
There is no bleed nipple on these slave cylinders. You have to bleed it through the banjo. I bled out all the old fluid and I put new fluid in the resevior and in the banjo I used a cable tie to keep the slave cylinder compressed while I pump the clutch lever air bubbles were coming out and now there's none but the clutch isn't working. There in no pressure at the lever when I pull in and the slave cylinder is decompressed I know I'm doing something stupid or not doing something small but I just can't figure it out.
-
hi i have seen the other threads on bleeding the clutch but it just doesnt seem to be working for me at all! i got a new slave cylinder as the old one crapped itself! but i cant get the fluid from the resevoir out. i pump it and the first pump a wee squirt comes out but after that nothing. any help would be appreciated.