Jump to content

greenlepard

Members
  • Posts

    8
  • Joined

  • Last visited

Contact Information
 
   
  1. Clened up the stator coils and magneto. Ran a new ground to motor mounts from cdi. Starts second kick cold.
  2. So I'm thinking it needs a stator. I'll check the resistance. Sparks ok with a plug against the head, but when hooked up to a spark tester it was very weak. Anyone reading these ramblings have any thoughts?
  3. So here's the stator, seems OK I think. Not sure about the copper plate on the coil top right in the pic though. It looks like its been rubbing.
  4. Got the puller and seal while I have it apart. Anything to watch for on these bikes? My first beta
  5. It broke a bit of the cover off where the chain guard meets the cover. Gonna silicone the new one up, maybe drill a drain hose too, idk.
  6. Trying to order a flywheel puller and some things. Hopefully it is just the timing. Bikes had a few quwerks since I got it.
  7. Just noticed there is a chunk of the ignition cover missing and signs that water has gotten inside
  8. I might have deleted the thread I started earlier. Trying to figure out why my 2001 rev3 won't fire. Has decent spark, new top end, carb tangs set low with little movement. 80:1 94 octane with stabilizer. The addict suggested maybe a woodruff key, so I'm about to check that out. Killing me that it won't start
×
  • Create New...