Jump to content

exile

Members
  • Posts

    4
  • Joined

  • Last visited

Contact Information
 
   
  1. Hi, thanks for the reply, the strange thing is that the I/D is the same as the thread on clutch centre nut. I have bought a new 3mm thk washer that goes behind the clutch, there is also one inside the basket isn't there? it would be great if you could send me a drawing that you are confident is correct. Have you stripped your clutch down before? any does and don'ts please? Many thanks robayres1958@btinternet.com
  2. exile

    242 Clutch

    Has anyone got any good info in the nine spring 242 clutch, the drawing is a little confusing, the 3mm spacer that sits in the castellated drive that goes into the back of the clutch looks to have another shim on the top of that, mine did not have one when I stripped it
  3. Hi, you sound as if you have gone into the bike in some depth! I have just started mine, I removed the primary case to find a washer in the bottom !!!! no damage, but at the same time, cannot find a home for it? the clutch has been off at some point as the tab washer has been butchered and the centre nut was loose. the problem I have is that there is only one shim under the clutch basket but the drawing shows 2, I have the 3mm one that sits inside the castle drive to the basket, any words of wisdom please all the best242.pdf
  4. I am rebuilding a Montesa 242 and although the bike is low hours and relatively untouched, when I washed the clutch case and gearbox out with petrol, what looks like thrust washer dropped out of the primary case, evidence as you can see, a ham head took the clutch apart, the nut was also loose, has anyone any advice on dismantling these clutches please? Many thanks 242.pdf
×
  • Create New...