[Sherco Fajardo 2022 250cc - two problems]

Thank you ! I search a little fuel line like your

Now with a new jet the carb work better !   I put a fuel filter

[Sherco Fajardo 2022 250cc - two problems]

the exhaust had burn the hose Is brown

New jet the bike works very well, i stop the bike ...same problem.  Now i put a fuel filter , reclean the carb and i test

[Sherco Fajardo 2022 250cc - two problems]

Hi !

New Sherco new problem

First , the exhaust melt my hose !  The keihin is very close !  Maybe can i use adesive termal protection on the exhaust?

Second, when the bike is "hot" it restart only with full open throttle 😕(3/4 kicks) .  Is full stock

Idle jet 45

Needle JJH

Main jet 125

Thank you so much !!

[Flooded bike won't rev]

Maybe the coil ??

[Sherco ST 2013 - Gear problem]

The shift, the gearbox work good !! ???

Thank you so much !

[Sherco ST 2013 - Gear problem]

I found spring shift "almost" broken  and i change it , i put a new drum , i control the shift lever (APICO).

Now i hope and i check the bike with the engine on and use the old sherco lever!

Next step is open the gearbox

[Sherco ST 2013 - Gear problem]

Hi ! I have a problem with my Sherco ST 2013 shift , i can't put the 3rd gear other times the 4/5th .  The shift can't run fine every time.

I put off the clutch for check all the springs shift and the drum .

- Maybe the spring shift doesn't work fine ( Sherco code:M110)  Pedal does not return to position  well -  Luckily i have the new spring

- I turn the drum with my Allen key and i can't put all the gear , 1&2 are ok  but 3/4/5  sometimes they go in but sometimes they don't go out anymore (like pic) , i need move the wheel.   Is very hard change gear. Same problem when the engine is on.

I hope i don't must split the motor

Thank you!  Sorry for my english

 

 

[Formula front brake calliper - Rebuild or change?]

Split link ! Nice idea !! Thanks

I will use temporarily the braktec 2020( I bought it yesterday) and rebuild the Formula

[Sherco 2014 brake/clutch levers]

I think brake master cylinder is AJP ,  check on the top of the brake fluid container

 

[Formula front brake calliper - Rebuild or change?]

Thank you !! I check the bolt and i buy the new caliper !

[Formula front brake calliper - Rebuild or change?]

My Sherco ST290 2013 has a Formula front brake,  one piston of the calliper is bloked .  I have two option , rebuild the calliper (i need a Forumula tool for open the calliper) or buy a newer maybe better .

The front brake master cylinder is AJP.  What caliper can i buy & fit? Braktec ??

Thanks

[Help-ohlins sherco fit]

Chris from Splat shop help me and send a smaller bearing spacers ! It's a fantastic shop 

[Help-ohlins sherco fit]

Tomorrow i will call  splatshop

[Help-ohlins sherco fit]

25mm ,  i found the 24 mm on the shop website but i need remove 2mm of material . My other shock is very small

[Help-ohlins sherco fit]

I bought a ohlins mono last week, now i try put on my bike sherco 13  st290. But doesn't fit like the other ammo . The top and the bottom are too big, doesn't enter .  3mm too big. What Can i do?

[The Mysteries of my ST290 '13]

Good, it works ! Thanks

 

[The Mysteries of my ST290 '13]

"This off-set flywheel timing key allows you to advance your ignition timing without modifying your stator or cases"

It change the ignition timing maybe of 2 degree.    If you tell me "use the old position" i use the old position , thank you ! 

Old pic:

[Sherco st250 2014]

2013

[The Mysteries of my ST290 '13]

-I check the wooodruff key because i have a problem with switch on my bike, it starts random .   I found this !  Woodruff key to advance ignition! WTF

 

 

I just replaced with an orginal sherco key, but now i don't find anyone chisel mark ! Now the only way is the dial gauge?

 

-Second question is.... What yellow do I have to buy for the '13 frame?

Thank you so much!!

 

I

 

[Help - 2014 exhaust on 2013 ST290]

The fuel hose is not too close at the chain & rear tire and it doesn't move ,  i think this is the only way

Maybe Saturday i get off the rear shock

 

[Help - 2014 exhaust on 2013 ST290]

Yes, i think is melted buy the previous owner... but it works . I will buying a new one.

little offtopic : Wich shock is that?  The tampon is Ohlins

[What colour of blue]

I wanna find the yellow for the sherco '13 

[Help - 2014 exhaust on 2013 ST290]

With the shock on doesn't fit, i try try but nothing . For remove the shock i need Allen wrench n.9 , i must buy it.

 

[Help - 2014 exhaust on 2013 ST290]

This afternoon i try, remove silencer's plastic trim and for last remove the rear shock.  I wanna buy a new 2014 front pipe or build an adaptor because i don't find a Sherco adaptor

My old exhaust is full of oil/carbon, inside is totally black and i can't open it.  Maybe i must cut in 2 piece or burn

[Help - 2014 exhaust on 2013 ST290]

Thank you cabby maybe they give me a wrong exhaust -.-"