Jump to content

Wheel Bearings Size..


beta rev 3
 Share

Recommended Posts

 

 
 
 

Hi everyone

you can get just about any bearing cheaper and as good or better than manufacture's item if you have a vernier caliper and a little knowledge of bearing jargon. Here's a handy guide and good web supply site.

Measure the bore, diameter & width & punch or if available read off 4 digit reference number on bearing rim and into search on site. You will get a list of options. Each option will start with 4 digit number (eg 6205, single row deep grooved - main bearing for Bultaco Sherpa) and if other than the basic single row deep grooved item will have letters and numbers following. These refer to seals or specialised bearings (eg 6205 2rsr, single row deep grooved with 2 rubber seals - rear wheel bearing Bultaco Sherpa) . A visit to the FAQ on the site below will unravel these codes.

Its worth getting to know the codes as you can, for example, upgade unsealed wheel bearings (specified for my model 49 Bultaco) to bearings with seals which can stand up to immersion and a pressure washer. This can also be done with seals (which most bearing suppliers also stock) as again, for example, better than a single one contact sealing surface (specified for sleeve gear next to engine sprocket ditto Bultaco) is to upgrade to one with attached dust shield to keep grit away from seal.

I've found http://simplybearings.co.uk/shop/index.php very helpful but there are other suppliers on the web and probably a local supplier.

Personally I always specify a known good quality beaing such as SKF. There are some rubbish bearings out there.

Tim

Link to comment
Share on other sites

 
 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
  • Create New...