Jump to content

Jast


jast
 Share

Recommended Posts

 

 

That orange wire should be connected to  the CDI. There should be a two wire harness hardwired into the cdi consisting of ...I think.. a Black with white tracer?, and the other will be your orange...this is what your mystery wire connects to. Good luck

Link to comment
Share on other sites

 
 

Hmm, mine has an orange wire coming out of the left side of the cdi along with that one with the male bullet end, possibly been torn out.? Look closely under that heat shrink tubing at the base of the left side cdi wire(s) exit point..hopefully there is some remnants left to solder your orphaned orange wire back onto. Hope you do not have to buy a new one :(  $$   Good luck

Edited by pauls320
Link to comment
Share on other sites

 
 

Did you give splatshop a try?    Sometimes its possible to carefully carve/dig/ dremel?? out some of the epoxy and expose enough to solder end onto and then reseal with sikiflex or similar material. Best of luck  

Link to comment
Share on other sites

 
 
 
 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
  • Create New...