Jump to content

Mickb

Sherco st125 clutch problem.

Recommended Posts

I have recently had the engine out of my st125 .On refitting the clutch push rod dropped out. When refitting  the slave cylinder it appears the either the push rod is not seated or slave cyl piston is out too far (tried pressing it back in). So when built the clutch is always disengaged. Sherco web page down so can’t see diagrams, any ideas. 
cheers.  

Share this post


Link to post
Share on other sites
 

Well, if you haven't operated the clutch with the engine out, the slave cylinder piston shouldn't be any further out than it was when you removed everything. So I would say that the pushrod isn't sitting correctly at the clutch cover somehow, or something is assembled incorrectly. Either way should be quite easy to see the problem if you just whip the side casing off and take a look.

Share this post


Link to post
Share on other sites
 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...