March 11, 201016 yr Did anyone come up with a wiring diagram to install the KDS36100 100A controller on a new 36V
March 12, 201016 yr I haven't yet - and unfortunately, looking at my workload I'm not going to have a chance to make one up until May at the soonest! Ah, well, better too much work then not enough, I suppose... Sam
March 12, 201016 yr I should add, BTW, that it's not too hard to figure out. Just try to eliminate as many connectors as possible when you're wiring it in and check the ones you leave alone. the stock crimped ones aren't perfect. I used all waterproof heat shrink connectors. Sam
March 12, 201016 yr Even a picture of the Kelley-to-OSET connectors would be a great help, or maybe forwarding the info provided by Ian? Thanks.
March 14, 201016 yr See pics below. I'll try to add some more description soon, but I thought getting them up here was a good start. Note that I machined the tabs off either side to fit the controller between the frame rails - this is only one of many ways to fit it. The speed control pot isn't used, neither are the black/white wires coming out the controller. All the connectors are Walmart heat shrink waterproof connectors - over in the trailer section here in the US. Sam Edited March 14, 201016 yr by samandkimberly
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.