lance_b_1

hey guys, thanks, I went to Mobley's, and he gave me the bushing I needed, big thumbs up and it installed easily. New sprocket, and I went over the whole bike checking everything. I had engine out of frame for paint and the whole bit so i addressed a lot of issues. I bought from a friend who bought it years earlier from a kind of two bit mechanic, and he hadn't done anything with it, so I knew it needed a thorough going over. Aside from coating the inside of the tank, it all appears to be on the up and up. it fired up within three kicks, and runs strong. Haven't noticed anything out of the ordinary. Thanks again!

hello, I need to jump right in with a question. I tried a few searches but am coming up empty handed. So, my Bultaco Sherpa T appeared complete when I got it, and months later when I get to maaking it run I realize a few parts are missing. The side cover was put back on to look complete, even though the clutch rod and ball bearing were missing, and the flywheel nut was missing. I also failry certain one my sleeve gear bushes (111-047) is missing. I can see one way down on the shaft, but not near the end, and I have what seems like too much play on my sprocket shaft. My questions are- am I missing one based on this photo? Where can I buy one- I have had zero luck searching OR, can I make my own? Is it anything fancy or is it just a bronze bushing that spins between the two shafts? thanks!

hello, just saying hello. My name is Lance Busch, I own a Bultaco Sherpa M49. I'm just getting it back on the road after purchasing from a friend. Here she is before I tore it down for a refresh: I also have a '76 TY175 I've completely resurrected and am looking forward to riding this summer! nice to be here!