skram

Well I finally got the puller today and pulled off the flywheel. Do points look bad? Anything stick out as a sure problem? Did a fair cleaning... This wire that runs up to the headlight looks like it needs to be replaced... or should I buy a whole new one?... Inside of the headlight, notice the block where the wires connect... there is a pair of black wires that are not connected to anything and in the manual the diagram does not show these... hmmmm?? what do you think?? cheers, skram

Thank you for the reply feetup, I did not get into those items because I do not have a flywheel puller and those are all located behind the flywheel. I will be ordering a puller tomorrow.

Could not achieve spark this afternoon. I went through the wires and found that the ones going into the case to behind the flywheel were pretty well worn so I fixed the ones that needed to be fixed. STILL NO SPARK! Any suggestions? New to these machines but they are very basic... don't know what I am overlooking? skram photo 1. when I opened the case and saw the wires tucked in there corroded and split photo 2. close up of wires photo 3. after wire clean up, trying to get spark

What model is this?

Hello, Bought this off of the original owner a few years ago. Came with original manual and sales receipt. 753 miles. He told me it was a '67, but the identification charts on bultaco.com do not have my serial number (403 541)... any input? Have not tried to start it yet, I have just power washed it. Any advice on what to look over or change prior to starting? Original owner had it running a couple years ago... tomorrow I will clean carb, revise wiring, change spark plug and put in some fresh gas! Will report with an update. Any input on model year would be helpful! -skram