malc

is 75 gearbox oil ok for it?

master cylinder seals gone & previous owner bodged up the actuating pin so not getting stroke required so ordered 2 sets & will do front brake at same time, stripped clutch & came off in 1 lump all stuck together so will clean & re fit then should be good to go. Thanks for all your help

Thanks for all the previous advice motor now running really well, apart from clutch has no feel at lever & wont work bleed thru, all air out & still same, could this be sticking clutch if so am I best to strip the clutch or try to release by moving the bike in top gear, or could the master or slave cylinder seals gone, which would you advise to check first. Also front brake wont bleed up either pistons pushed back free but cant get lever to push them out? both on AJP systems bike must have been stood 3yrs as I know to what would you recomend?

I dont suppose you have some close up pics of how the unit fits to the frame as I cant make out how it secures

Also can someone please enlighten me to what colors go to where & what they are for please I have a yellow wire on its own, & a red, green & white wire together in the loom. Many thanks in advance

http://www.ebay.co.uk/itm/290813266736?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649

I have a 200 sherco 2000 model with the square exhaust I am trying to sort the wiring as there is no CDI unit or diode etc. cant find any readings & schematic to understand what I need I have been told that a vespa CDI works I do have 1 which someone has given me its a mitsuba cmd01 but colours dont match so I am running blind. I have the stator plate leads, fan & temp sensor what else do I need? Thanks Malc