haybob

Thanks for the advice

When replacing the main bearings do I fit them so they are flush with in side of the crank casing , has there is no lip to stop the bearing from going in to far and letting the crank touch the engine casing ,, thanks for any advice

How to check the crank big end for ware ? , It feels tight and no play , also the side movement of the Con rod is just over 1 mm , I will replace the small end . is there any other way to make sure all is ok before I rebore cylinder and rebuild the motor , thanks

Thanks all for your advice, I have decided to replace the big end , better safe than sorry , Haybob

How to check the crank big end for ware ? , It feels tight and no play , also the side movement of the Con rod is just over 1 mm , I will replace the small end . is there any other way to make sure all is ok before I rebore cylinder and rebuild the motor , thanks