bikemad04

The seals was gone in my master cylinder, seems to be a common problem as I have heard of others and the bike had done a max of 3 hours since new, if anyone else has the problem I would check your master cylinder seals, you can get a seal kit, my dealer sent me one free of charge, cheers.

Nice one mate hopefully have a go later.

Thanks buddy il try that

Thanks mate.

Dealer is sending me a bottle of fluid, is it the same procedure to bleed a clutch as the brakes? Cheers

Thanks mate great help ?

I'm going to ring them tomorrow, hopefully they will cover the cost for me to take it somewhere local as they are a 3 hour drive for me

Hi all recently bought a 17 st 250 factory, went practicing today and the engine was warm went to engage gear and the bike was stalling / leaping forward, using the adjuster on the lever I maxed it out and the best I can get is as soon as the lever is not touching the bar the bikes wants to go, which is far to low to have control at low speeds, any ideas? Bike is brand new and has done 3 rides, cheers.