Baby

Working as designed. Thanks, gents!

Great. I will check it out tomorrow and report back.

Thanks! I tried turning the shaft by hand without the flywheel and then with the flywheel seated but not tightened in. Does the flywheel need to be fully installed?

Hi, first post, other than the introductory post in the other forum. I am in the process of getting my TY250 in good running order. In the process of checking the timing and the points gap, I notice that the points don't seem to open at all, no matter how they are adjusted. What am I missing? The bike starts on the first or second kick and runs fine up to half throttle. (I just installed a new carb and ditched the autolube pump, so I have some smoothing out to do. But I wanted to dial in the ignition before I go too far messing with jetting.) Mystified.

Hi, All. I am a long-time lurker. Finally getting my ty going again after more than a few years running it only a couple times/year. I'm in Sonoma County, CA with no places to ride nearby. Thanks in advance for all of the help!