Adding 2mm to base gaskets will also change the port timing slightly, whereas increasing the head gasket will not. Is it your recommendation to lower compression AND change port timing by using a base gasket, or just to lower compression by using a head gasket?
The throttle on the 2012 is WAAAY too scary. Comes on way too hard with small throttle inputs. What methods are there to calm this beast down?
1) What alternatives are there to slow the throttle cable twist grip? I use the Domino side pull (slow) trials version now.
2) Changes to timing? Advance or retard?
3) Changes to cylinder compression or gasket thickness?
4) Changes to ignition mapping available?
5) Porting mods?
6) Reed mods?
7) Cylinder alternatives? Is there a 250 piston/barrel available that will fit on the 290 engine?
I am 65 years old and a expert-level rider in my previous life, so don't give me this "You gotta train harder and get used to it" approach. I don't want to shoot up and over 15' vertical steps...I just want to slow things up a bit.
It is impossible to bounce the rear on the 2012 . Can't even get it off the ground no matter what I do. Front brake is clean and acts like a trigger on a gun, but still won't lift the rear end. Damping is WAAAAAY too slow. Sag is about 10-15mm with no rider. Is there any damping adjustment on the stock 2012 rear shock and where is that bugger anyway?
