4 replies to this topic

[PetrS]

Hello,

does anyone know, how to repair leaking oil level window on Sherco 320 4T 2008?

I have special loctite silicon to seal engine block, head, etc. but I don't know, if I can put the window out without destroy it.

Or is there any better way to solve this problem?


Thank you very much.

Best Regards

Petr.

[rockyrider]

I think if I had to I would clean the area extremely well with solvent, with bike laying on it's side. Then I would apply a thin coat of clear silicone, then let set for 24 hours. If that's helpful.

[PetrS]

rockyrider, on 08 December 2010 - 11:54 AM, said:

I think if I had to I would clean the area extremely well with solvent, with bike laying on it's side. Then I would apply a thin coat of clear silicone, then let set for 24 hours. If that's helpful.

Hello rockyrider,

thank you for reply, but I have red silicon and it will not look nicely. Don't you know, if I can put the window out from cover without destroy it?

[Greg]

PetrS, on 08 December 2010 - 12:05 PM, said:

Hello rockyrider,

thank you for reply, but I have red silicon and it will not look nicely. Don't you know, if I can put the window out from cover without destroy it?

it used to leak on my beta, i'm sure it could be tightened up (threaded). just a thought.

[PetrS]

Greg, on 08 December 2010 - 07:10 PM, said:

it used to leak on my beta, i'm sure it could be tightened up (threaded). just a thought.

Thanks, but I found this: http://www.splatshop...vel-window.html : ))