Jump to content

94chas

Members
  • Posts

    14
  • Joined

  • Last visited

Posts posted by 94chas
 
 
  1. Hi All

         the clutch on my old 309 mont is worn out anybody out there know if the 315 has the same clutch plates as these are easily available  or where to get 309 plates from.

               have been using atf in it is this suitable.?

                           Regards Chas 

  2. Hi All

         having a few clutch issues with my 1989 montesa 309.Its fine when cold and warm but when hot neutral is difficult to select has silkolene light gear oil 750ml fitted anybody know if this is correct have no information on the bike,anybody used ATF ?

                                  Regards Chas

  3. Bought a 309 new in 1989 powerful soft motor rode it most weekends in club trials for about 4 years never had any problems with it then put it in the shed for 20 years just getting it up together to ride in the air cooled mono class,most parts seem to be available inmotion seem to have a few parts.Never seen another one for years,only bike I ever kept,others came and went.

  4. Hi all

          just bought an old 309 mont been stood many years would like to know the gearbox oil capacity and type,also same for the forks.

            Going to drain the old fuel & clean out the carb see if it will run,then I,ll have some more questions for you guys.

                        Thanks in advance

                            Regards Chas

  5. is it a 250 ?

    a friend of me has an 260cc those are proper hrc bikes very rare

    best regards bob

    Hi Bob yes is a 1989 250 its totally orgional had very little use only one i have ever seen. Regards Chas

  6. Hi have just fished my old tlm 250 out of the garage to start riding again after a long lay off,see there,s alot of interest in them were they hand built,has a rear silencer with HRC written on it.Thanks in advance. Chas

 
×
  • Create New...