Jump to content

pat52

Members
  • Posts

    7
  • Joined

  • Last visited

Contact Information
 
   
  1. Nope still nothing, i have ordered a new rectifier unit as the one I have is slightly damaged anyway but they wanted
  2. Hello all I have a gas gas txt pro 2005. I have recently changed the fan motor ( Which still works plugged into a separate power source) but it only lasted one ride before the fan will not cut in! it works a bit if you rev the engine really high. I have tried joining the two wires of the thermostat together to no avail and have tried a method shown elsewhere on this forum to replace the rectifier to a cheap one (i know i know :-) ) Has anyone got any ideas as to how best problem solve this situation without replacing both all of the components? Past experiences may help. Many thanks in advance! Patrick
  3. pat52

    Gas Gas Spark Plug

    Thanks for your replies I currently run 70mm castrol tts for 5 litres super unleaded, i will try a clean out of the exhaust and running the 5ES to look for a difference. Has anyone had any noticeable difference from the iridium 5EIX plug? Or am i just wishing?
  4. Hi All I have naturally ran the spark plug in my 2005 txt pro 250 that came with the bike NGK BPR6ES, after looking at the manual online i have noticed this says run BPR5ES. I know the difference is heat range but should I use the 5?. Also could this be the reason for a smoky bike ( even with a fully cleaned system, running good fuel with low mix). Thanks!
  5. I have lots of play in the rear suspension of my 05 txt pro, i have changed the linkage kit and understand i need to replace the "rose" joint/ bearing. I have been quoted
  6. Yes it is an all balls kit! Thanks for your reply, it is good to know i'm not going mad. Just need to get a bearing for the shock for a decent price as splat shop quoted
  7. Hello everyone I am fairly new to trials bikes ( 6 months experience) and have stripped my gas gas pro 250 to replace the linkage kit, everything is replaced except i have one bearing spare ( 7 in the kit) i have replace the four in the dog bones and two in the swing arm connection. Does anybody know where the seventh is? The bearing in the bottom of the shock is also gone but is different. Any help is appreciated
×
  • Create New...