bantamsam

Hi Guys Would this work on a D7 3 speed? Cheers Sam

Hi all I am looking for a tiger cub cup and cone set to move forward with my cub project. I have emailed various dealers and looked on ebay with no look can anybody help? These are the measurements: OD 42.81mm/1.685" ID 1"/25.4mm Depth 0.4"/10.17mm I also have another set of yokes with a smaller diameter stem that i can use however i have forgot the exact size so i will upload this later. Any help guys??Cheers Sam

Yeah only 2 mountings! And i am going to make a bash plate out of a sheet of alloy that im getting from rufforth this weekend.I will probably attach it to the downtube with some sort of U clip and attach it to the rear somehow. Hope this helps a bit, hopefully i will have it done in a couple of weeks so i will upload a pic of bashplate once finished. Cheers Sam

That was before i painted it however i cant seem to upload the other photo of it painted? This may of worked

Hi Dan Im a fellow Yorkshire lad myself and my cub frame has already been chopped about like your thinking of doing and it looks alright to me i have a rolling frame at the moment and it has massive ground clearance would you like to see a photo? Cheers Sam

Hi How easy is it to just cut it in half and weld it? Cheers Sam

Hi Somehow i don't think it is the wide type as my dads cub and Road bantam both have the same swing arm width and my dad says if you let the tyre down a bit it catches? Cheers Sam

I have a sunday job but doesnt pay right well Cheers Sam

Hi Guys I am new to this forum i have a cub frame and modified subframe i am basically building a cub rolling chassis with all cub parts then putting a bantam engine in as that is all i have spare any bantam engine modifications or tiger cub parts that i should buy though they will have to be cheap as i am only 15 Cheers Sam Photos so far

Hi Suzuki Hi Suzuki 250 What width and length did you lengthen the swing arm by because i am thinking of getting my swing arm altered? Cheers Sam