Hello everyone,
My name's Pete and I very recently purchased a 2001 250cc rev 3 which with a quick once over didn't seem in to bad a shape however I now realise I should not impulse buy and that perhaps I could have found something a little more loved.
So from front to back....kill switch not working, header bolt holes chewed and gasket missing, various fixing bolts missing/sticking out/cross threaded, bash plate bent, motor did run but I used it for 15mins or so yesterday and it got bloody hot and didn't want to start again,closer inspection shows a thermostat wire not bloody connected, rear mudguard a bit of a mess as someone has started to strip it to paint it but then left it half stripped, rear brake is pretty poor and rear wheel bearing pretty much had it.
I'm concerned mostly about the motor....everything else is running repairs/cosmetics but my experience is limited and I'm not really sure where to start....although the plug is the wrong one there's a good spark and what seems like good compression, it did start briefly earlier but was pretty Smokey and died after 20 seconds or so at which point I abandoned it for today and decided to confess online of my limited knowledge and hope that I haven't just thrown my money away....all encouraging comments help and heckling welcome in equal measures....
Pete.