When replacing the main bearings do I fit them so they are flush with in side of the crank casing , has there is no lip to stop the bearing from going in to far and letting the crank touch the engine casing ,, thanks for any advice
How to check the crank big end for ware ? , It feels tight and no play , also the side movement of the Con rod is just over 1 mm , I will replace the small end . is there any other way to make sure all is ok before I rebore cylinder and rebuild the motor , thanks
How to check the crank big end for ware ? , It feels tight and no play , also the side movement of the Con rod is just over 1 mm , I will replace the small end . is there any other way to make sure all is ok before I rebore cylinder and rebuild the motor , thanks
