Hi there I have been given a Bantam (Ihave been told a d14) not sure though which is in alot of bits. I have been thinking of converting it into a trials bantam. Has anyone have done this before and what should i need to know or consider before i start the wheels need new rims and spokes anyway
Hi there I have a 175 and one of the flywheel magnets has broken This might be a stupid question but does it need 4 magnets or would 2 opposite be ok if they were by the coil when it needs to spark or is there anywhere i can get a magnet from.
Hi there I have a BSA Bantam d14 ( I think) in bits and wanted to convert it to trials trim . I dont Know alot about these bikes in any trim so what would i need to look at doing and where could i get the parts like exhaust any help would be helpful
regards Neil
Hi there I have just started back trialing after a few years off and want to know where all the bikes from around 1990 have gone there used nto be hundreds of 305s 245s and the like (beta tr 35 and Zeros) where did they all go
Hi looking good did you cut the front pipe of the original exhaust or is it a different pipe and is it alot lighter than the original complete exhaust cheers Neil
Hi there I have a ty 175 with a standard exhaust I have seen aa 175 with a ali center exhaust but with no back box I have found them on jk hirst but are they any good
They look a lot lighter than the standard one fitted
http://www.jkhirst.co.uk/acatalog/Rear_Silencers.html
regards Neil
Hi there I have aquired some beta techno forks with wheel and brake . Has any one fit such forks to a ty 175 and if so what bearings and mods did they have to tend to any input will be great cheers neil