DanyScorpa

2016 300, with the updated 2018? "battery less" ignition, starts and runs 1st kick when adding a 12 volt source, no spark, no fuel pump without 12 volts added, when running at 1800-2000 rpm its charging at 14.4 volts, just seems to not be creating enough electricity for starting requirements.. Help!

Hi, can you still send a digital copy of the 2016 model manual?

Thanks for the info, from the time I acquired the bike, the adjustment on the clutch arm was pretty much bottomed out, as in the threaded adjuster was almost flush with the lock nut, and I would say that there is approximately 12mm of clutch arm rotation before it engages the push rod, the angles are ok, yes the clutch arm pivot is easily bent, everything lines up well for proper slave to clutch arm function, my thoughts were that if the adjustment was maxed that there is wear that could be addressed and rectified, as I'm sure from the factory they wouldn't have been "cranked" in so far? I will look into the older yz parts to see if I cam locate one or at least the o.e. specs on it, cheers!

Hi All, giving the 03 sy a once over, I found that there is alot of travel in the clutch arm before I would feel the pushrod connecting with the clutch plate, I have removed the ball bearing and pushrod and there seems to be enough wear on the pushrod ends, does anyone know what the actual spec for the length of the pushrod? Is it shared with any other yamy' engines?