cantgetaname

When i took my carb off to clean it out i put it back so as it was sitting up right with no angle and when i started the bike it red lined and reved its max the throttle was not stuck it was because there was no angle on it im sure. and when i managed to free the revs it sure took its time to come down the revs.

Hi there again tryed the SUPER UNLEADED petrol but no diffrence at all even tryed the jetting settings but nothing changed still the same old knock took the top of the head off had a look there is no play on piston wrist pin just as it should be the bore is absolutley spotless i think i need a main bearing re-build.

Hi there i have the same problem with my bike does your piston let a "chuck" noise when you give the bike a sharp throttle and let it rapidly close my bike is the ssdt rep that jarvis rode in 2000 sherco bultaco. If you dont mind could you tell me what these parts cost you and where you got them from. Thank You Jorge PS look at my forums please if you get time.Thanks

Hi there my front /manifold pipe has some dents in it i repacked my muffer a few days ago and have rode it once or twice i have never touched the center part of the exhaust scince i bought it in november

Thanks wayne speaking of which i had to replace the crank case seal beacuse it was smoking real bad i think i need to replace my main bairings could all this work come to more than

Hi there again im using normal unleaded fule at 100:1 to 1 gallon exactly of fuel. This is my first trial bike how do i fix the jetting as you suggested? i have the little screw out at 3 notches would main bearings have an affect on this? Thanks very much for all your help Jorge.

Sherco Bultaco Graham Jarvis Replica Picton Knock Hi there i have a Sherco bultaco Graham Jarvis Replica 2000 modle 250 cc when i open the throttle half way and then let it close there seems to be a knock that comes from the piston/cylnder area. The fly wheele has a little play in it i think its my main bearings it only does this knock when it is warm.its driving me insain. What could it be? every opinion counts.

Hi there i have a Sherco bultaco Graham Jarvis Replica 2000 modle 250 cc when i open the throttle half way and then let it close there seems to be a knock that comes from the piston/cylnder area. The fly wheele has a little play in it i think its my main bearings it only does this knock when it is warm.its driving me insain. What could it be? every opinion counts.