scotty97 Posted July 22, 2010 Report Share Posted July 22, 2010 Is there a certain procedure for fitting a kickstart to a 2007 sherco 290. dont really know how to fit the ball bearing, spring etc....... Quote Link to comment Share on other sites More sharing options...
trialsnutterman Posted July 22, 2010 Report Share Posted July 22, 2010 With everything cleaned, fasten the lever upside down in the vice, put the spring in the angled hole and the ball on top of it, use a bit of grease to hold them in position, then firmly push the bottom piece of the kickstart into the hole until it goes fully down, then finally insert the grub sreew with some thread lock, this should be tightened till it touches the bottom then backed off 1/2 a turn so the kickstart can swivel easily Quote Link to comment Share on other sites More sharing options...
scotty97 Posted July 22, 2010 Author Report Share Posted July 22, 2010 I've had an o-ring delivered with mine, should that be an o-ring or a washer????????? Quote Link to comment Share on other sites More sharing options...
tony27 Posted July 23, 2010 Report Share Posted July 23, 2010 O-ring Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.