ric h Report post Posted January 17, 2015 WTF! A bolt on both sides of a pivot? How the heck are ya supposed to get these out? Last thing to remove before the frame powdercoat. Grrrrr! Quote Share this post Link to post Share on other sites
digga Report post Posted January 17, 2015 Hi Ric If there the same as the 2012 ? Put a torx wrench in both sides of the mounting bolt and undo in a anti-clocwise direction,, the underside bolt should come out, then from underneath tap upwards with a drift or pin punch and the top shaft will come out, this has a 8mm female thread in it. Yes it's a bazar way of fixing pegs (unlike everyone else) BUT the pegs dont seem to wear on the shaft much as there a 10mm dia rather than 8mm like all the others. Hope this helps. Quote Share this post Link to post Share on other sites
ric h Report post Posted January 17, 2015 Thanks Digga.I'll try it. Quote Share this post Link to post Share on other sites
