Just a simple pusher about .1mm narrower that the bearing outer race and .1mm narrower than the bearing inner race. Either use a press or hammer to push em out
1
17 replies to this topic
#16
-
- Members
-
- 40 posts
Member
- Location:Ireland
- Bike:Looking for Sherco
- Club:Highciders MCC
Posted 25 May 2011 - 11:48 AM
Sorry for the crude drawing of the swingarm but it was only done quick!!
Just a simple pusher about .1mm narrower that the bearing outer race and .1mm narrower than the bearing inner race. Either use a press or hammer to push em out
Just a simple pusher about .1mm narrower that the bearing outer race and .1mm narrower than the bearing inner race. Either use a press or hammer to push em out
#17
-
- Members
-
- 920 posts
Advanced Member
- Location:Sydney, Australia
- Bike:250 2006 (07 frame)
Posted 26 May 2011 - 10:45 PM
No that's perfect....thanks
But I assume you drove out both bearing cadges at the same time like this?
Best of balance.
Neo
But I assume you drove out both bearing cadges at the same time like this?
Best of balance.
Neo
My Bike ....www.trialscentral.com/forums/garage/vehicle/516-sherco-250-2t-racing-red/
TRIALS....It's not life or death....It's much more serious than that!!
TRIALS....It's not life or death....It's much more serious than that!!
#18
-
- Members
-
- 40 posts
Member
- Location:Ireland
- Bike:Looking for Sherco
- Club:Highciders MCC
Posted 27 May 2011 - 05:12 AM
Neo, on 26 May 2011 - 10:45 PM, said:
No that's perfect....thanks
But I assume you drove out both bearing cadges at the same time like this?
Best of balance.
Neo
But I assume you drove out both bearing cadges at the same time like this?
Best of balance.
Neo
yep,both at same time, then used a long bush and pressed the bearings in from each side with the bush in place so they would be aligned right
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
