Jump to content

mattlloyd50

Members
  • Posts

    24
  • Joined

  • Last visited

Contact Information
 
   
Recent Profile Visitors
 
 
3,215 profile views
 
  1. Hope you didnt mind me posting the pics. If so let me know. Matt
  2. these are photos i found on another site but as i found them useful thought id post them here, they should have about 80ml of 7.5 w oil in them. the oil level should be 65mm from the top when filled.
  3. the photos seem to have been jumbled up and im too tired to sort them so the procedure was compress spring with straps remove collet remove spring tap end cap off with chisel (carefully) remove valve core and pour oil out of valve press damper into shock body and remove c clip ​pull damper rod out of body, (this was quite difficult as the o ring on the damper got stuck in the c clip groove. I pressurised the body with the compressor and popped the first one out and pulled the second one like a slide hammer, both methods worked well.
  4. i have just rebuilt a pair of betor 360mm shocks and couldnt find any photos before i started so thought i would add some.
  5. im still happy with the result. the only thing i should have done differently is where i welded the back on, i should have pop rivited it to make it easier to replace the packing in the future.
  6. first trial with the new muffler on sunday, im pleased with the result. felt more snappy from idle to quater throttle.
  7. i have seen a few bikes with straight through exhaust mufflers and like the idea but also like the look of the original exhaust. i decided to cut one open and see what i could do. i have attached some photos that should be self explanitary but if not please ask. i fitted it to the bike this afternoon and it sounded different but still as quiet as the original setup, it also felt quite a but more perky but this was only in quite a small area so i will give it a proper test on monday once its painted and refitted.
  8. i found this a while ago and have just got round to translating it, there are still a few headings that i couldnt figure out but it shouls be useful. https://www.dropbox.com/s/gps74puq7hs3pnl/SWM%20MODEL%20SPEC%20SHEET.xls?dl=0 hope it helps. matt
  9. im planning to go practicing and try moving the stator plate to a few different positions. is it safe to try moving it from one extreme to another. hopefuly this will give me better understanding of its effect.
  10. how does advancing or retarding the ignition affect the feel of the bike at low revs? thanks matt
  11. this is how i do mine, i use one strap from the loop on the tow ball bracket, this is fed over the seat and hooked onto the right footrest i have also extended the rear wheel support and put a strap around that.
  12. you will need proof of age or dating certificate from the importer. mine was about
  13. the reason i asked is because i have had the bike about 8 years, it sounds fine and runs well. i have recently decoked and repacked the exhaust, the carb clutch gearbox and ignition are also good. i dont know if its down on power as i have nothing to compare it to but dont want the piston to fail and cause other damage.
  14. hi i have a swm 240 and have no idea how long the current piston has been fitted. what lifespan would you expect to get from a piston before changing it or the rings? also could i tell the condition of a piston with a cylinder compression guage and what would be a good pressure? thanks for any help matt
×
  • Create New...