keith0673

It was already set up correctly but still jamming till I can not operate the lever Anyone want a 1996 beta techno before I launch it of a cliff

If it was goosed....

Thanks for the info Would the slave cylinder cause this to happen too?

Ok lineaway all adjustment sorted out min freeplay in lever, Put bike on side so I don't lose my oil. Pull in lever 4 times and resistance begins another 6 pulls and it is jammed so again i just push the rod in the centre with my finger and the clutch lever is back to normal. Iv started the bike up and I have no clutch even when clutch feels ok to building resistance. Do you think I can have too much travel in the lever that mite be why it's jamming? Sounds stupid but I'm really confused

Sorry the master cylinder is fine it is new. I'm talking about the clutch housing cover were there is 4 Alan key nuts.

Thanks so what do I need to alter please advise I do appreciate any information

Hi all please help me I'm going round the bend here. Why does my clutch lever get more resistance the more times I pull it in till I just can't pull it in? Lay bike on its side taken cover off and if push in the centre the rod thingy goes back and lever becomes normal to operate, why is it sticking should there be a spring to push it back?

I know that it an old post but I'm having the same problem and it's eating money Hhunter please finish this can help lots of people So far I've changed clutch plates, master cylinder kit, gear oil and so on