I am about to start a clutch basket change out on the sherco, using a new basket and the installation kit.

This involves the riveting of the assembly. Although I have previous experience of fitting solid rivets could anyone offer any usefull advice on the same and possible areas to avoid. Can this task be implemented using a rivet snap (dolly) or will I require some form of press? Thanks in anticipation - Geebee

I took the easy way and ordered it pre-assembled when I had to change mine.

no riveting involved.

Edited July 19, 200818 yr by ZIPPY

The parts book shows them as a 4mm diameter rivet. I would think you could set them with a common shop air hammer with a flat tool while backing up the end against an anvil surface.

But, I have never had to do these specific parts. Maybe phone your importer for more info.

Thanks Guys

Geebee