Jump to content

Sign in to follow this  
beardy2000

Bsa B40gb

Recommended Posts

I need some help with my b40 engine! Im in the middle of rebuilding my engine and Im not sure about the crank shaft bush in the outer casing. It looks like a steel insert within a piece of rubber and is'nt a very good fit with the crank. Drawings only show an oil seal. Is this correct or has some one played with it? would be very greatful for any info.

Share this post


Link to post
Share on other sites
 

Hi I still have the problem with my outer casing for the crankshaft. Is it possible to get a bush for the casing if it runs on a bush or is it just ment to be a seal?

Could really do with some help as Im dieing to get her fired up again.

The engine is an end fed crank gb model.

Thank you for any info

Share this post


Link to post
Share on other sites
 

Speak to C & D Autos 01564 795000 They will give you an answer and supply the part, I hope.

Share this post


Link to post
Share on other sites
 

Hi again! Thank you fot your advice, After finding the time to look at the engine properly I found that it should have a lip seal but the old seal looked very much like it had an insert after being rubbed by the crank.

Going back together slowly!!

Share this post


Link to post
Share on other sites
 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...