simonty Posted September 6, 2005 Report Share Posted September 6, 2005 (edited) Hi, Could anyone give me some instructions on how to change my 97 techno fork seals. Thanks in advance. Simon Edited September 6, 2005 by simonty Link to comment Share on other sites More sharing options...
rev3guy Posted September 13, 2005 Report Share Posted September 13, 2005 Hi Simonty: I cant remember which forks the 97 techno came with but I think they are Paioli... Ryan Young has a section on fork seal replacement for the Sherco with Paioli forks that might be helpful to you, here is the link http://www.shercousa.com/pdfs/sherco_fork_...placement-1.pdf You might want to confim the oil capacity for the Beta since I am sure the amounts are different than the Sherco, my 2004 Rev3 takes 370cc in the right and 350cc in the left. If your seals are leaking just a small amount you might try tearing off about an 5-6 cm of 35mmm film, carefully inserting the film between the fork and the seal and going around the seal to clear any dirt that could be causing the leak. Sometimes that is all the problem is and not necessary to change out seals. Good luck T Link to comment Share on other sites More sharing options...
dr nick Posted September 26, 2005 Report Share Posted September 26, 2005 How did you get on with your seals....one of mine has just started leaking. Was the Sherco manual on RYP any help. or did you get it done in a garage Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now