March 28, 20206 yr That orange wire should be connected to the CDI. There should be a two wire harness hardwired into the cdi consisting of ...I think.. a Black with white tracer?, and the other will be your orange...this is what your mystery wire connects to. Good luck
March 31, 20206 yr Author Any ideas which one . 1 is black the other white and black can't see were the orage one goes
March 31, 20206 yr Hmm, mine has an orange wire coming out of the left side of the cdi along with that one with the male bullet end, possibly been torn out.? Look closely under that heat shrink tubing at the base of the left side cdi wire(s) exit point..hopefully there is some remnants left to solder your orphaned orange wire back onto. Hope you do not have to buy a new one $$ Good luck Edited March 31, 20206 yr by pauls320
March 31, 20206 yr Author Yes found the end at the bottom of cdi and sites for replacement can't find any for a 2011
March 31, 20206 yr Did you give splatshop a try? Sometimes its possible to carefully carve/dig/ dremel?? out some of the epoxy and expose enough to solder end onto and then reseal with sikiflex or similar material. Best of luck
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.