OregonComrade Posted April 13, 2020 Report Share Posted April 13, 2020 Stupid question - think. I have a 260 so the lower spec Tech forks. The spring preload side (left side), what is the base setting? The Manual talks about "turning" it, what direction? I pulled up the tech docs directly from Formula and it says: "Our advice is to start leaving the adjuster in middle position (you can reach the standard position by screwing it completely and unscrewing it 5 turns). After this, you can try to modify the preload, turning the governor one turn at a time, in way to feel every possible little change." My hunch is CCW is less and CW is more? Based on the paragraph above I would assume turning it CW until it stops and unscrewing it CCW by the 5 turns? Thanks! Quote Link to comment Share on other sites More sharing options...
lineaway Posted April 13, 2020 Report Share Posted April 13, 2020 Your hunch is correct, but I would think the base line would be no pre load. 1 Quote Link to comment Share on other sites More sharing options...
OregonComrade Posted April 13, 2020 Author Report Share Posted April 13, 2020 56 minutes ago, lineaway said: Your hunch is correct, but I would think the base line would be no pre load. I would think the same thing.... 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.