crash bandit Posted February 22, 2006 Report Share Posted February 22, 2006 I've had to replace the clutch plates on my TXT 270 but I've not sure in what order they go on. I have 7 fibre plates and 6 steel plates and 1 half steel and half fibre plate. Looking at it carefully I think the half/half plate goes on last with the fibre outermost !!!! When I started the bike up and put it in gear I almost wheelied through the back of the shed. Is this the correct way Quote Link to comment Share on other sites More sharing options...
gasgasthermo Posted February 22, 2006 Report Share Posted February 22, 2006 (edited) clicky try this you ay have lost the ball bearing or push rod have you looked to see if the out side pressure plate moves did a simmalar thing to a gasgas jtx lost the ball bearing hope this helps Edited February 22, 2006 by gasgasthermo Quote Link to comment Share on other sites More sharing options...
landrover Posted February 23, 2006 Report Share Posted February 23, 2006 (edited) Half plate first cork down,then cork /steel/cork/steel till they are all in. on the clutch basket one of the pin's is marked like a cross the pressure plate is also marked something like a I,this mark must either be in line with the mark on the pin that's marked or directly opposite.ie Turn 160 degrees do not put the mark at the side of the marked pin. hope this helps Edited February 23, 2006 by landrover Quote Link to comment Share on other sites More sharing options...
crash bandit Posted February 23, 2006 Author Report Share Posted February 23, 2006 Thanks for the info. I have put the plates in the way you said. I did notice the marks but didn't know they needed to be put on in a special way!!! I will have to take it apart again and line them up. I have run the engine for a short while, will this damage anything? Quote Link to comment Share on other sites More sharing options...
landrover Posted February 24, 2006 Report Share Posted February 24, 2006 crash bandit, it should read 180 degrees not 160, you should not have done any damage Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.