gasgasthermo
Members
-
Joined
-
Last visited
Everything posted by gasgasthermo
-
If it dose it excessively could be the voltage regulator.
-
-
Yeah you can still buy them, there were some on ebay not sure if they are still listed although about
-
you might have tweaked the floats if you have taken it apart so check the float height.
-
GasGas
-
could polish them with metal polish !
-
That could be down to a number of factors thou ! e.g handle bar position, leaver height etc
-
-
progrips on the racing which is what i assume you are talking about ?
-
he has been doing a few enduro events but i don't know if he has given up trials.
-
oh rite good hope that sorts it
-
Could Try V-mar, the uk dealer being Road&Trials, not sure if they will fit your Montesa though but might be wort asking ?
-
you might as well pop a new little end bearing in whilst you have the top end off.
-
how much do these barrels and pistons cost from s3 ?
-
are gasgas doing a 250 raga this year then ?
-
there are a series or star self taping screws that are in the under side of the air box remove all of these with the air box off and then put loads of silicone were the two half's join push the two halfs together and the reinsert the screws and leave to dry .
-
i have also used one on a 125 racing using the same jets that are used in the normal ones my only problem so far is that i have snapped two slides not sure weather it is to do with bad manufacture or because the spring is two strong or weather its because of the metal tick over screw.
-
-
yes these boots are good they have a water proof lining so if you have to go in any streams then ur feet will stay nice and dry and warm. just make sure when you wash you boots you put saddle soap or boot water proofing on them to stop them going hard.
-
hi i am about to repack my silencer and was wondering what packing to use. also i was wondering if you just drill out the rivets, remove the end cap, then hook out all the old packing and then poke packing back in then put the end cap back on. or dose the middle tube come out and then you wrap that in packing? how tight do u wrap the packing also ?? thanks in advance
-
same here !!!
-
i got fork protectors on mine to save the aluminum tubes from rocks ect
-
-
was it a 3 or a 5 ???
-
he was when u did it haha