gasgas4life

Ok thanks

Has anyone got the entries for this weekends BTC? Thanks

Does anyone have a link to any results from the Southern Experts last weekend? Thanks in advance.

Stick your knees or legs out to counter balance, thats the best way

The oil i use is Putoline light gear oil and have used it since new. I doubt it is the oil because loads of people i know have shercos and run this oil and have no trouble at all. And it does it all the time, low and high rpm.

A while ago I posted a topic about clutch plates for my 09 sherco 125. We replace the plates because I was getting a strange juddering noise when holding the clutch on its biting point, this caused the bike to be very awkward to ride. We have changed both metals and friction plates and still getting the same problem!! Its hard to explain but basically the bike 'squeals' and judders when held on biting point. Anyone know how this problem can be overcome? Many Thanks.

Was a good trial! Good photos too

Thanks for you help guys, will give local dealer a call to find out.

I need to order a new clutch for my 09 ShercoR 125 and was wondering whether like it said in the spec that it has a Race clutch? Or is it just the master cylinder that is different? Because if it does then i need to order Race ones! Thanks in advance.

Thats why I am going to get a van... cheapest i could get a 1.0litre corsa which was mid 90's was nearly

As I am 17 and have booked my driving test I am currently looking for small vans which can fit two bikes in. First looked at Ford Connect but they are too expensive for my first vehicle so was wondering about a Vauxhall Combo. Can anyone that has one tell me if they fit two bikes in and please could they post up a picture? I don't want to buy a van and end up with it only fitting one/none bikes in! You may be thinking that a car with a rack would be better for me but van insurance is alot cheaper than car insurance for a 17 year old! Many thanks

Won't let me play it! Sounds like a good vid. just comes up with a box in left hand corner. help !

Well... it was surpose to be non-stop. All the other observers allowed riders to stop except from that observer on number 18! Even clerk of course told him to let them stop but he wouldn't have it. But to be honest that observer (who im not saying his name) is sooo grumpy and can't hear either! Hes well known in the SE and everyone moans about him! Its a shame really because observers are so important in trials and without them we would be stuck. Anyway i agree it was a awesome trial! like it always is every single year, great thanks to sidcup and Freestyle (CLICK ME)

Wahoo! All sorted now! Went up and down the gears fine when i tested it today. You were all right - that gear was surpose to spin because the new gear span on the bush fine. It must have taken a big knock to move that bush but luckily the shaft was in good condition. Could have been worse i surpose! Thanks again for your input, helped alot

Yes we found both teeth lieing in the bottom, they had been snapped clean off so wasn't any small lose bits about. Still cleaned it all out with oil though! Thanks you for input guys!