Jump to content

dazmo33

Members
  • Posts

    7
  • Joined

  • Last visited

Contact Information
 
   
Recent Profile Visitors
 
 

The recent visitors block is disabled and is not being shown to other users.

 
  1. We have been struggling with the clutch to get a decent bite position and feel for my boy. It also changes during a trial. I stripped it to have a look to see if there was anything obvious and was just comparing to some plates from my older bike.
  2. Few questions if anyone can help please? 1) Gas Gas parts give the three orings on the slave cylinder (1 outside that hold the needle roller, two hydraulic seals inside) as the same. Can that be right? 2) Are friction and/or steel plates interchangeable from old and new models? 3) What significance do the crosses on the standard steel plates have? Thanks in advance.
  3. Sorted with a new spring (may have been weekend away from it and fresh approach!). Last conundrum are if you can help: Does last washer on KS shaft go on before case is fitted ? T1001824 I appear to have 2 ally spacers left over. Hoping these not come from another project (hangs headpin shame). Can anyone identify if they should be in gas gas clutch area because I can't see where!
  4. PSorted with a new spring (may have been weekend away from it and fresh approach!). Last conundrum are if you can help: Does last washer on KS shaft go on before case is fitted ? T1001824 I appear to have 2 ally spacers left over. Hoping these not come from another project (hangs headpin shame). Can anyone identify if they should be in gas gas clutch area because I can't see where! Thanks.
  5. thanks chaps. I rechecked it and it is not all the way in / flush as you correctly observed. I removed the spring and remounted and it fitted ok so as the spring is wound it prevents it from fully engaging. Is it the way I'm coiling it or should I get another spring? Thanks.
  6. Hi. Hi all Am rebuilding my bike and am replacing kickstart and idle gears. I put shaft and new kickstart gear in and found the kickstart and idle gears do not disengage. I have re tried with the old shaft to see if the newer version was the issue. Same result. I am completely at a loss. I'm pretty sure it's indexed ok. Kickstart have done the 360 degree twist. Have I done some simple / silly wrong that someone can identify. I'm wondering if I got sent wrong parts. Bart gear doesn't have a B on it but read elsewhere that the old aren't available anymore so maybe they don't need a B on it? New bart gear slides on both old and new shaft (read elsewhere they are not interchangeable). Should be this hard - 4 hours in garage so far ..... Thanmks for any replies. Daz
  7. 3.00 by 12 pit bike tyres fit. Search for Oset tyres and pay £35 Hi. Do 3.00 by 12 tyres really fit the Oset 16 or is that a typo? Thanks.
×
  • Create New...