Yamagodden

Hi all just been looking at this ty250 I have , do you think this has been sleeved down???

..Well guy that's up for debate, I have a couple more phone calls to make on this, if that is a dead end i will have done all i can. It will be put up for debate as a separate issue on here for every one to decide !!!

Would this be a john shirt mod or another garden shed job??

Has the 90 degree pipe been changed from standard pipe , ie bigger diameter . I can see how its shortened as you have described

Is this standard size pipe into the silencer box?

It looks like it . I wonder what else it has ? Has anyone got any links to more pics of this bike

Also has a rd carb fitted ,

Rear done as well. Grease nipples, drilled for lightness

Nice old period mods ,

Ok thanks , I did not know it's a magazine article, I see it has the ow10 works titanium kickstart and looks like half width hub in front, must be the development majesty, same as sam brownlee 320 in northern trial pic!

It has trail 70 and the works kickstarter

It's the one on the advert "Yamaha majesty" looks like the spec and in French... might have trial 70 on the clutch housing..

Is there any more pics of the yellow majesty of this link? Looks like the majesty advert?

Engine pic

Front wheel just a identifying point on the 320 development bike then, does any one know what the identity this bike was using??

Cheers , keep them coming..I see the advert on yamaha trail for the majesty has the yz hub, again on the sam brownlee article he is riding in the northern trial..that's got a speedo drive by the looks of it. Which a mx would not have so was added. Both these pics must be the development bike then?

Looking for pics of john hulme and mick Andrew's bikes, I cannot seem to find any other than John's bike on this site, any ideas?

Been looking and taking photos today..only info I have been told is it's not a majesty but a standard frame moddifed to mono. In a garden shed. He knows the bike and the builder but has not told me the builders name...had tape out it's got 12" ground clearance with flat front tyre..rear frame supports are drilled for lower shock mounts as per majesty.. had no look contacting MA or JES yet... any one help me on this

Better pic

Rear gussets on the frame, rear shock mounts are cut off but can just be seen...

It came on a engine I bought. I would not use it, building a 37a spec lump for a 67 anglian, my thoughts were cart as well

Has anyone seen this on a villiers iron barrel?

Spoke to sam , limited info back. next step is john shirt or mick Andrew's..

The only bike I have found like this is in the pressreader article sam brownlee. There is a picture called The first godden frame!. Have a look and see what you all think

It now has linkage but it looks like early mounting points directly on frame..