ossa 250 gripper jets

[pygar]

Have just been given a mikuni carb could anybody tell me which jets to use for my 250 ossa gripper.

Thanks in advance

Robin

[reggie]

I think you will need a main jet and a pilot jet.

[bashplate]

reggie.....i think he was hoping for the jet sizes

[bisby]

Have just been given a mikuni carb could anybody tell me which jets to use for my 250 ossa gripper.

Thanks in advance

Robin

Robin, look on page 2 in twinshocks then -any ossa gripper guru`s out there, you will see my mikuni settings

note though my carb is a 28mm. Steve.

[pygar]

Thanks for the sensible replay steve,have seen post,my carb is a 26mm and bike a 250 but should give me a starting point.

thank again

Edited December 14, 2011 by pygar

[bisby]

Thanks for the sensible replay steve,have seen post,my carb is a 26mm and bike a 250 but should give me a starting point.

thank again

Robin, my gripper is also a 250 but it has a MAR piston (2mm extra) so i think its 244cc i also put the window in the back of the piston. I put the mikuni on because i wanted the revs to pickup quicker, i have also reduced the flywheel weight on the cush drive, then also drilled some big holes in the clutch basket. I feel if i go anymore i will loose its grip low down the revs.

steve.