griffiths of wales Posted August 31, 2005 Report Share Posted August 31, 2005 Any fellow Seeley owners in here know the best way to change the fork seals? Just found that one of my fork legs has a serious 'ding' right where the seals sit and it looks like a welding job may be required. The damage is so bad that most of the width of the top seal is visible, I will probably have to get a sleeve made to match the top of the leg, section it,weld it into position and machine top bore to suit the new seal. Any dis-assembly/assembly info warmly welcomed. Thanks again, Mark. Quote Link to comment Share on other sites More sharing options...
tlrs Posted August 31, 2005 Report Share Posted August 31, 2005 are these not the same marzocchi forks like the fantic? maybe look for info/parts there... Quote Link to comment Share on other sites More sharing options...
griffiths of wales Posted August 31, 2005 Author Report Share Posted August 31, 2005 Not sure..I'll post a pic, thanks for the tip though...cheers, Mark. Quote Link to comment Share on other sites More sharing options...
martinm Posted August 31, 2005 Report Share Posted August 31, 2005 Mark Seeley forks use the same casting as early 125/200 Fantics and SWM's. The only difference is that the bolt holes are larger on the Seeley, so should be ok to use. I only have a right hand (speedo) side available.....any use to you. Martin www.motoswm.com Quote Link to comment Share on other sites More sharing options...
griffiths of wales Posted September 1, 2005 Author Report Share Posted September 1, 2005 Thanks for the offer Martin....mines the bloody left side! never mind, I'll get the leg welded and machined. Now that I know that the leg is common to a few other bikes I can always go looking for a few spares, thanks again, Mark. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.