October 23, 20187 yr Hi , I have bought a new rim and spokes and have my old back wheel ready for relaceing but I have to remove the hub brake liner to get at the spoke holes in the hub anyone done this before , how is it done. Bultaco Sherpa 350 Edited October 23, 20187 yr by Ciaran
October 24, 20187 yr Ciaran - The info. you want (I think) was covered in an earlier topic listing. "199a running refurb. - new member cosmo" on Aug. 8th. last. Sorry, tried to create link but lack i.t. skills........ HTH
October 24, 20187 yr Been a long time now, but I think there is a press fit annular strip of sheet steel that covers the spoke ends, it should just prise off, have a close look in the hub, the rear sprocket is likely holding it in place. Bye, Peter B.
October 24, 20187 yr Yes, as above, there is a thin cover plate that fits over the spoke heads, just prise it off. It's probably stuck on with a bit of corrosion
October 24, 20187 yr Author I have seen the plate didn’t want to go at it until I got some info, thanks very much
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.