Jump to content

Sign in to follow this  
bondy

TY 80 final End drive oil seal

Recommended Posts

 

Yes fairly certain Mr Yamaha wouldn’t make it that difficult. No need to split the cases, this is a seal that has to take punishment so just like the other TY models its a gentle lever out or use various methods like self tappers and grips but usually just a simple appropriate sized lever will flick it out. Lay the bike over so aa to keep the oil in the box if you are not draining out. Plenty of grease around the new seal lip and I believe that the sleeve that the seal rubs against comes out too so give it a good clean and grease.🙂👍

Share this post


Link to post
Share on other sites
 

Nice 1 I wasn't sure I normally do bultaco and there the same the seal just pops out I normally use a blunt rounded leaver to tap 1 side and the other pops out I then flick it out with a small flat driver cheers for the replay 

 

Share this post


Link to post
Share on other sites
 
6 minutes ago, bondy said:

Nice 1 I wasn't sure I normally do bultaco and there the same the seal just pops out I normally use a blunt rounded leaver to tap 1 side and the other pops out I then flick it out with a small flat driver cheers for the replay 

 

Hope all goes well👍👨‍🔧

  • Like 1

Share this post


Link to post
Share on other sites
 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...