vectradam Report post Posted July 3, 2019 hi my 2018 trs 280 has no clutch. there is only a little fluid in the master cylinder. I assume the seals must have gone in the slave cylinder. Is this an easy job or could it be something else ? many thanks Quote Share this post Link to post Share on other sites
taff_d Report post Posted July 3, 2019 Probably just the seals or a loose connection if you have lost the fluid, never had to do one but i can't imagine it been rocket science to do it. Quote Share this post Link to post Share on other sites
baldilocks Report post Posted July 4, 2019 (edited) You just need to remove the clutch inspection cover not the full clutch case so the water pump stays in place. I think the seals are just o rings, easy to fit, be careful not to drop the washer and thrust bearing that are on the underside of the case and sit on the slave cylinder. Remember it's mineral oil not dot4 You can see all of the parts if you look at the parts diagram on TRS UK site Edited July 4, 2019 by baldilocks Quote Share this post Link to post Share on other sites