pitley Posted February 9, 2006 Report Share Posted February 9, 2006 Hi folks, Any one here know the volume of oil to put in the standard forks of the above bike, and what is the best pre mix ratio useing fully synthetic oil? Any help appreciated. Cheers Quote Link to comment Share on other sites More sharing options...
fivemeister Posted February 9, 2006 Report Share Posted February 9, 2006 If you get stuck, ring John Shirt (Gas Gas importer) in Buxton, Derbys. He made them in the first place and should be able to help. Quote Link to comment Share on other sites More sharing options...
outlaw dave Posted February 9, 2006 Report Share Posted February 9, 2006 The stock TY 250 Twinshock forks take 123cc's each leg 10w. Quote Link to comment Share on other sites More sharing options...
pitley Posted February 10, 2006 Author Report Share Posted February 10, 2006 Many thanks Dave.. Quote Link to comment Share on other sites More sharing options...
twinshockdude Posted February 11, 2006 Report Share Posted February 11, 2006 did a lot of messing about with my majesty forks,the best way is to remove springs and fully compress forks fill to 5" from top with 15w oil,then add or remove spring packers to suit,the amount of packers will depend on how buggered your springs are,mine needed 1" hope this helps !! Quote Link to comment Share on other sites More sharing options...
feetupfun Posted February 11, 2006 Report Share Posted February 11, 2006 did a lot of messing about with my majesty forks,the best way is to remove springs and fully compress forks fill to 5" from top with 15w oil,then add or remove spring packers to suit,the amount of packers will depend on how buggered your springs are,mine needed 1" hope this helps !! <{POST_SNAPBACK}> Be careful when adding additional preload to TY250 springs because they are close to coil binding when fully compressed with standard preload. Better springs than Yamaha springs are available for twinshock TY250s from B&J Racing in the US. They have a higher rate, decent coil spacing and work brilliantly together with 5WT and 10 WT fork oil for my 88kg. The 5" oil measurement technique works very well and when done properly is more accurate for keeping both sides the same than measuring the volume and assuming that both sides are equally "empty" to start with. It's a good idea to do a travel check after fiddling with oil levels and preload. To do this fit a cable tie on one fork tube above the dirt scraper and with the caps off, move the forks to full compression position ie metal to metal. Measure the position of the cable tie from the lower fork clamp. Then get the bike ready to ride and slide the cable tie down a bit and go for a ride where you can really load up the forks ie a decent drop off. If you aren't getting the cable tie back to the position it was with the caps off, there is something unnecessarily limiting your fork travel. The problem may be that the fork oil level is too high in one or both sides, or the springs are coil binding (coils are touching together). Quote Link to comment Share on other sites More sharing options...
pitley Posted February 13, 2006 Author Report Share Posted February 13, 2006 Exellent help you guys. What about the pre mix ratio? Cheers Quote Link to comment Share on other sites More sharing options...
scotty Posted December 31, 2006 Report Share Posted December 31, 2006 pitley i use 40:1 comp 2 if that helps i wouldn't go leaner than 50:1 keeping in mind the engines aircooled! and belongs to the old skool of two-strokes ossa, bultaco ,etc!!! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.